The product information label is located either on the back or bottom of the clock. The clock model number and serial number are essential for obtaining parts or service. The product information label identifies the clock model number and serial number. Place the pendulum hook over the pin or through the slot on the end of the pendulum guide, and lower the pendulum until it is hanging securely on the pendulum guide. While holding the pendulum guide with one hand, slip the pendulum through the front door with your other hand. To hang the pendulum, locate the pendulum guide through the front door or back access panel.

Carefully remove this film before hanging the pendulum.

Some pendulums have a colored protective plastic film covering the pendulum disk. NOTE: To perform the following steps, Howard Miller suggests wearing cotton gloves or using a soft cloth when handling parts. Open the front door and remove the white plastic insert holding the minute hand at the 3:00 location (this insert is not used on all models).ДЇollow the remaining instructions as they apply to your clock.ДЇollow these instructions for hanging pendulum. (See figure 1 & 2)ДЇor clocks with a pendulum, cut the rubber band or remove the metal spring clip from the back side of the movement by first pulling one end free. When possible, pull in the direction shown to remove. Remove foam, Styrofoam, and cardboard from around the movement and chimes. Mechanical Movement Mechanism Parts вЂ“ Figure 2ДO NOT PULL ON THE RUBBER BANDS TO BREAK. Kieninger Triple Calendar Moonphase Clocks.Kieninger Tubular Chime Grandfather Clocks.Hermle Astrolabium and Tellurium Clocks.

Howard miller serial number list